- 19 -
2.4 Displaying Measurement Data
Numbers are attached to measurement data. Up to 50 data can be stored in internal memory.
Use the [UP] and [DOWN] switches among the panel switches to view stored data.
The [UP] switch shows the next number data, and the [DOWN] switch shows the previous number
data.
・ Batch deletion of all measurement data can be performed.
☞
‘3.20 Batch Deletion of Measurement and DIF Standard Data’
∙ When data is being displayed and the [MEAS./HOLD] switch is pressed to
begin measurement, measured data is stored at the number following the
number currently displayed. If the registered data already exists at the
number, its contents will be overwritten.
To Next Page
Loading...
