- 62 -
3.18 Luminance Display Format
Set whether to show the measurement luminance number in a decimal or exponential format.
Use the following procedure to set the format.
1 Switch to the function mode to display the [DISPLAY]-[Luminance Format].
☞
'3.1.2 Entering/Returning from the Function Mode'
2 Press the [CHANGE] switch.
3 Press the [ROTATION] switch to select the desired value.
The value cycles as follows:
Decimal → Exponential
4 Press the [ENTER] switch to accept the displayed value.
3.18.1 Luminance Display Format
Set the number of digits to show for the measured luminance.
Use the following procedure to set the number of digits:
1 Switch to the function mode to display the [DISPLAY]-[Luminance Decimal].
☞
'3.1.2 Entering/Returning from the Function Mode'
This setting screen is not displayed, except that the luminance display format is set to the
“Decimal” mode.
2 Press the [CHANGE] switch.
3 Set the number of digits in the integer and decimal portions of the measured value. The range
is 6 to 10 digits for the integer portion and 0 to 3 digits for the decimal portion. Note that total
number of digits cannot exceed 9.
☞
'3.1.3 Setting values'
4 Press the [ENTER] switch to accept the displayed values.
To Next Page
Loading...
Need help?
General
