Topcon SR-LEDW - Selection of Over Range Detection in MANU

- 60 -
3.16 Selection of "Over Range" Detection in MANU
In SR-LEDW/SR-UL2/SR-UL1R/SR-3AR, if the "over range" error occurs, measurement is stopped.
If “OFF” is set, measurement is performed without detecting the “over range” error.
Setting
1 Switch to the function mode to display the [MEASURE]-
[MANU OVER ON/OFF].
☞
'3.1.2 Entering/Returning from the Function Mode'
＊ ＭＡＮＵ ＯＶＥＲ ＯＮ／ＯＦＦ ＊
ＭＡＮＵ ＯＶＥＲ ＝ ＯＮ
· The initial condition is the “ON”
· This setting screen is not displayed, except that the measurement mode is set to the
“MANU” mode.
2 To change the setting, press the [CHANGE].
If press the [ROTATION] switch, ON/OFF is changed to each
＊ ＭＡＮＵ ＯＶＥＲ ＯＮ／ＯＦＦ ＊
ＭＡＮＵ ＯＶＥＲ ＝ ＯＦＦ
3 Press the [ENTER] switch to decide the value.
DIF.
ABS.
UP
LAMP
DOWN
MEAS.
HOLD
FIELD
FUNCTION
ENTER
CHANGE
ROTATION
SHIFT
Note
DIF.
ABS.
UP
LAMP
DOWN
MEAS.
HOLD
FIELD
FUNCTION
ENTER
CHANGE
ROTATION
SHIFT