- 27 -
3. Settings
3.1 Function Mode
3.1.1 Settings
The operation panel can be used to make the following settings.
∙ Table color selection
☞
‘3.2 Table Colors’
∙ Measurement mode selection
☞
‘3.3 Measurement Mode’
∙ Frequency setting (during FREQ mode)
☞
‘3.3.1 FREQ Mode'
∙ Integral time setting (during MANU mode)
☞
‘3.3.2 MANU Mode’
∙ FIX INTEG mode setting (during FIX I mode)
☞
‘3.3.3 FIX INTEG Mode’
∙ FIX FREQ mode setting
☞
‘3.3.4 FIX FREQ Mode’
∙ Integral time delay function
☞
‘3.4 Integral Time Delay Function’
∙ Delay time setting
☞
‘3.4.1 Delay Time Setting’
∙ Measurement method selection
☞
‘3.5 Single or Auto Run'
∙ Speed measurement selection
☞
‘3.6 Measuring Speed’
∙ High Speed Calibration
☞
‘3.6.1 High Speed Calibration’
∙ PC connection selection
☞
‘3.7 PC Connection Method'
∙ RS-232C parameter setting
☞
‘3.8 RS-232C Parameters’
∙ Data communication selection
☞
‘3.9 Data Communication Methods’
∙ Remote command terminate code selection
☞
‘3.10 Remote Command Terminal Codes’
∙ Correction factor
☞
‘3.11 Using a Correction Factor’
∙ Displaying and Editing the Correction Factor
☞
’3.12 Displaying and Editing the Correction
Factor’
∙ CIE Color Matching function selection (Visual field)
☞
‘3.13 CIE Color Matching Function(Visual field)’
∙ CIE Color Matching function selection (Type)
☞
‘3.14 CIE Color Matching Function (Type)’
∙ Measurement averaging selection
☞
‘3.15 Measurement Averaging’
∙ Average count setting
☞
‘3.15.1 Averaging Count’
∙ Configuration of “Over Range” Detection in MANU
☞
‘3.16 Selection of “Over Range” Detection in
MANU’
∙ Buzzer setting
☞
‘3.17 Buzzer’
∙ Luminance display format selection
☞
‘3.18 Luminance Display Format’
∙ Luminance display digit count setting
☞
‘3.18.1 Luminance Display Format’
∙ Maintenance reminder setting
☞
‘3.19 Maintenance Reminder Screen’
∙ Panel light on/off setting
☞
‘3.20 Panel Light Control’
∙ Batch deletion of measurement and DIF. reference data
☞
‘3.21 Batch Deletion of Measurement and
DIF. Standard Data’
To Next Page
Loading...
Need help?
General
