Topcon SR-LEDW - FREQ Mode

- 37 -
3.3.1 FREQ Mode
In the “FREQ” measurement mode, the frequency of the light source to be measured can be set.
Use the following procedure to set the frequency:
1 Switch to the function mode to display [MEASURE]-
[frequency input].
☞
'3.1.2 Entering/Returning from the Function Mode'
2 Press the [CHANGE] switch.
3 Input a desirable value according to "How to input a numerical value in the function mode". The
value which can be inputted is 1.5 to 250 Hz.
Setting Method
☞
‘3.1.3 Setting Values’
＊ Ｆｒｅｑｕｅｎｃｙ Input ＊
Ｆｒｅｑ［Ｈｚ］＝ ５０
4 Press the [ENTER] switch to accept the displayed value.
DIF.
ABS.
UP
LAMP
DOWN
MEAS.
HOLD
FIELD
FUNCTION
ENTER
CHANGE
ROTATION
SHIFT