∙ Standard sample data is stored at the number after the one currently displayed.
If the registered data already exists at the number, its contents will be
overwritten.
3 If the standard sample data has already been registered, select a desirable number for a new
standard sample data with the [UP] or [DOWN] switch.
4 For the standard sample data, press the [FIELD]
switch to confirm.
The screen will return to normal.
5 Perform measurement of color difference.
Measure the difference in the same way as the absolute values. The measurement mode can
be changed and auto run mode can also be used.
Switching measurement mode
☞
‘3.3 Measurement Mode’
Continuous measurement
☞
‘2.2 Auto Run’
After the measurement is done, the difference values will appear.
＃１０ ＡＵＴＯ ＤＩＦ ２．０
ｘ ＝ ０．０００１ ２．０
ｙ ＝ －０．０００３
Ｌｖ＝１．２４０Ｅ－０３ ｃｄ／ｍ＾２
∙ To change the standard sample number or input standard sample data, press
the [ABS./DIF.] switch to return to ABS. (absolute values), then press again to
get back to DIF. mode. Return to step 1 and follow the procedure.
To Next Page
Loading...
Need help?
General
