Topcon TRK-1P - Page 11

10
BASIC OPERATIONS
CHANGING THE MEASUREMENT MODE .............................................................90
MEASUREMENT MODE.....................................................................................90
TYPE OF MEASUREMENT TO BE DONE UNDER REF/KRT
MEASUREMENT MODE.....................................................................................92
TYPE OF MEASUREMENT TO BE DONE UNDER TONO/PACHO
MEASUREMENT MODE.....................................................................................93
CHOOSING THE EYE TO BE MEASURED........................................................94
WHEN MEASURING THE REFRACTORY POWER AND CORNEAL
CURVATURE RADIUS OF THE EYE .......................................................................96
PREPARATION BEFORE MEASUREMENT (REF/KRT MODE)........................96
TURN ON THE POWER ...............................................................................96
POSITIONING THE PATIENT.......................................................................98
ADJUSTING MONITOR'S ANGLE................................................................99
MEASUREMENT UNDER AUTO MODE (REF/KRT MODE)............................100
MEASUREMENT UNDER MANUAL MODE (REF/KRT MODE).......................105
DISPLAYING MEASUREMENT VALUES (REF/KRT MODE) ..........................107
DELETING MEASUREMENT VALUES (REF/KRT MODE)..............................108
WHEN MEASURING THE OCULAR PRESSURE AND CORNEA
THICKNESS OF THE EYE.....................................................................................109
PREPARATIONS BEFORE MEASUREMENT (TONO/PACHO MODE) ..........109
TURN ON THE POWER .............................................................................109
CHECKING THE MEASURING NOZZLE ...................................................110
AIR CHECK .................................................................................................111
POSITIONING THE PATIENT.....................................................................113
ADJUSTING MONITOR'S ANGLE..............................................................114
SETTING THE SAFETY STOP ...................................................................114
MEASUREMENT UNDER AUTO MODE (TONO/PACHO MODE)...................117
MEASUREMENT UNDER MANUAL MODE (TONO/PACHO MODE)..............124
MEASURING THE CORNEA THICKNESS (TONO/PACHO MODE) ...............130
DISPLAYING MEASUREMENT VALUES (TONO/PACHO MODE)..................131
DELETING MEASUREMENT VALUES (TONO/PACHO MODE) .....................132
IN A CASE LIKE THIS ...........................................................................................133
TO STOP MEASUREMENT..............................................................................133
TO MEASURE THE RIGHT/LEFT EYE ONLY..................................................134
THE LIMIT ICON APPEARS AND THE MEASUREMENT IS NOT POSSIBLE ......136
THE NOZZLE LIMIT APPEARS AND THE MEASUREMENT IS NOT POSSIBLE ....137
ALIGNMENT DOES NOT START .....................................................................138