117
BASIC OPERATIONS
MEASUREMENT UNDER AUTO MODE (TONO/PACHO MODE)
SETTING THE AUTO MODE
In the initial status after power on, the mode is set to auto mode (AUTO).
1 Make sure the Measurement screen is on.
2 In case that no auto mode is set, press the of the control panel and
display the alignment bar on the monitor screen.
MEMO
Adjust the height of the automatic instrument table so that the patient
can sit on the chair comfortably and correct measurement values can be
obtained.
This operation is available even if the message "CHECK EYE LEVEL AND FORE-
HEAD, PRESS MEASURE SW" is displayed.
ALIGNMENT button
ALIGNMENT button
Alignment mark
To Next Page