92
BASIC OPERATIONS
TYPE OF MEASUREMENT TO BE DONE UNDER REF/KRT MEASUREMENT
MODE
Select the type of measurement to be done under the REF/KRT mode.
In the REF/KRT measurement mode screen, press the
of function button on the control panel and select the
desired type of measurement.
R/K measurement mode : Both REF mode (refractory power measurement) and KRT
mode (corneal curvature radius measurement) are done con-
tinuously.
REF measurement mode : Only REF mode (refractory power measurement) is done.
KRT measurement mode : Only KRT mode (corneal curvature radius measurement) is
done.
In the initial setting the R/K measurement mode is set, but this can be changed.
For details, see page 78.
MEASUREMENT MODE button
To Next Page
Loading...
