100
BASIC OPERATIONS
MEASUREMENT UNDER AUTO MODE (REF/KRT MODE)
SETTING THE AUTO MODE
In the initial status after power on, the mode is set to auto mode (AUTO).
1 Make sure the MEASUREMENT screen is on.
2 In case that no auto mode is set, press the of the control panel
and set the measurement mode to auto mode (AUTO).
SETTING THE MEASUREMENT MODE
This instrument can select the measurement mode from R/K (REF/KRT continuous measure-
ment), KRT (KRT measurement) and REF (REF measurement).
1 Make sure the MEASUREMENT screen is on.
2 Press the of the control panel and select the mea-
surement mode.
MEMO
Adjust the height of the automatic instrument table so that the patient
can sit on the chair comfortably and correct measurement values can be
obtained.
This operation is available even if the message "CHECK EYE LEVEL AND FORE-
HEAD, PRESS MEASURE SW" is displayed.
ALIGNMENT button
Alignment mark
ALIGNMENT button
MEASUREMENT MODE button
MEASUREMENT MODE button
To Next Page
Loading...
Need help?
General
