39
PREPARATIONS
INITIAL SETTING
In the INITIAL SET screen, buzzer sound, start mode, patient No., refractory power shift, mon-
itor display of typical value, method of corneal diameter measurement, etc. can be changed.
1 In the "INITIAL MENU screen," make sure that the cursor is on "INITIAL SET," and then
press . The monitor screen is changed to the "INITIAL SET screen."
SETTING THE BUZZER SOUND
The buzzer sound can be turned ON/OFF. Before shipment, it is set to "ON" (buzzer sound).
1 In the "INITIAL MENU screen," select "INITIAL SET" and get the "INITIAL SET screen."
2 Press the Set value change button or and select "ON" (buzzer sound) or
"OFF" (no buzzer sound) of "BUZZER."
3 Setting is done by pressing the Set item change button , and the cursor goes to the
next item.
To exit from this screen
• Press .
• Close the "INITIAL SET screen" and return to the "INITIAL MENU screen".
To return to the previous item in the screen:
• Press the Set item change button .
ENTER
EXIT
To Next Page
Loading...
