17
COMPONENTS
PAGE 1
After turning power on, the initial status of PAGE is as follows.
(5) Measurement mode button:
Switches the measurement modes of the ocular pressure measure-
ment and the cornea thickness measurement.
Pressing the Function button enables you to select T/P (ocular pres-
sure measurement/cornea thickness continuous measurement),
TONO (ocular pressure measurement) or PACHO (cornea thickness
measurement).
If is selected by in Page 2:
: Ocular pressure measurement/cornea thickness
continuous measurement
: Ocular pressure measurement
: Cornea thickness measurement
If is selected by in PAGE 2:
: Ocular pressure measurement/cornea thickness
continuous measurement
: Ocular pressure measurement
: Cornea thickness measurement
(6) Alignment button: Switches between auto measurement and manual measurement.
: Auto measurement
: Manual measurement
(7) Count change button:In the AUTO measurement, the number of measurements can be
selected between "single measurement" and "the previously set
number of measurements".
: Single measurement
: Previously set number of measurements
This is not displayed under MANUAL mode.
When the measurement mode is changed by the
, is returned.
(8) Safety stop button: Used for position setting to keep the measuring window glass from
the patient's eye during the measurement. For details, see page 113.
(9) PAGE selecting button:Changes the PAGE screen to another.
(5) Measurement mode button (7) Count change button (9) PAGE selecting button
(6) Alignment button (8) Safety stop button
30
30/60 button
60
30/60 button
MEASUREMENT MODE button
To Next Page
Loading...
