DNR-X-1G Series RACKtangle and HalfRACK Systems
Chapter 6 94
Programming CPU Board-specific Functions
October 2018 www.ueidaq.com
508.921.4600
© Copyright 2018
United Electronic Industries, Inc.
6.4.1 Help
Command
The help command provides a list of available commands:
DQ> help
help Display this help message help
set Set parameter set option value
show Show parameters show
store Store parameters (flash) store
flrd Re-read flash (flash) flrd
mw Write wr <addr> <val> [width,b] mw
mr Read rd <addr> [width,b] [size] mr
time Show/Set time time [mm/dd/yyyy] [hh:mm:ss]
pswd Set password pswd {user|su}
ps Show process state # ps [value]
test Test something test [test number]
simod System Init/Module Cal simod [routine]
default Default parameters default
reset Reset system reset [all]
dqping Send DQ_ECHO to <mac addr> dqping
mode Set current mode mode {init|config|oper|shutdown} [ID]
log Display log content log [start [end]] -1 = clear
logf Find entry in the log logf marker [start [end]]
ver Show firmware version ver [all]
devtbl Show all devices/layers devtbl [logic|verbose]
netstat Show network statistics netstat
pdj Print device object pdj <devno> cl
sd SD Card Commands sd <command> <arguments>
stat Display status stat [log]
nif Display nif object nif
clear Clear terminal clear
To Next Page
Loading...
Need help?
General
