EasyManuals Logo

UEi RACKtangle DNR-12-1G Series User Manual

UEi RACKtangle DNR-12-1G Series
120 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
DNR-X-1G Series RACKtangle and HalfRACK Systems
Chapter 2 9
The DNR-12-1G Series RACKtangle System
October 2018 www.ueidaq.com
508.921.4600
© Copyright 2018
United Electronic Industries, Inc.
Up to 12 DNR I/O boards can be installed in the chassis; DNR I/O boards are
functionally identical to the corresponding DNA boards for the PowerDNA Cube.
The only differences between RACK and Cube I/O boards are the mounting
hardware. The DNA version I/O boards are designed to stack in a Cube chassis.
The DNR version I/O boards are designed to plug into the backplane of a RACK
chassis.
Figure 2-5. Typical PowerDNR DNR-12 Board Placement
All UEI modules are available in both PowerDNA and Power DNR package
designs.
DNR-POWER-DC DNR-CPU-1000/-XX DNR-BUFFER
up to 12 PowerDNR I/O Boards
Table 2-1 Components in PowerDNR DNR-12 Enclosure
Item / Part No. Description
DNR-POWER-DC One isolated DC/DC Power Module/Power Monitor with status indicators, a local
on/off switch, and 4-pin Molex Power-In connector. (Refer to Section 2.6 for
detailed information)
DNR-CPU-1000,
DNR-CPU-1000-02,
DNR-CPU-1000-03
One dual-slot CPU/NIC module with status indicators, two Ethernet connectors
(Main and Diagnostic Ports), sync connector, reset pushbutton, SD card slot, USB
controller/slave ports (reserved), and a DB-9 connector for a serial port.
(Refer to Section 2.7 for detailed information)
DNR-BUFFER One for buffering address/control/clock lines (not currently addressable). (Refer to
Section 2.8 for detailed information)
PowerDNR I/O
Boards
Up to 12 front pull-out I/O boards (DNR boards are functionally identical to
PowerDNA Cube I/O boards but designed for installation in a DNR rack
enclosure). (Refer to Section 2.9 for detailed information)
DNR-BP-12 One backplane with two temperature sensors (see Figure 2-4 for diagram)
DNR-IO-FILLER Blank filler panels for all unused slots (see Figure 2-6. Note that this item is
optional / not included in price of rack)
Fans Four 8-volt cooling fans mounted on the rear of the enclosure (see Figure 2-9 for
air flow diagram)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the UEi RACKtangle DNR-12-1G Series and is the answer not in the manual?

UEi RACKtangle DNR-12-1G Series Specifications

General IconGeneral
BrandUEi
ModelRACKtangle DNR-12-1G Series
CategoryNetwork Hardware
LanguageEnglish

Related product manuals