DNR-X-1G Series RACKtangle and HalfRACK Systems
Chapter 6 99
Programming CPU Board-specific Functions
October 2018 www.ueidaq.com
508.921.4600
© Copyright 2018
United Electronic Industries, Inc.
DNR-12/6 systems come from the factory with IP addresses already preset for
192.168.x.x network. The factory IP address can be found on the label located
on the back of the DNR-12/6 enclosure along with factory-set MAC address.
After the IP address is set, you can establish communication with the
DNR-12/6 system using UEI’s PowerDNA Explorer (refer to Chapter 5 for more
information about PowerDNA Explorer).
6.4.4 Reset
DNR-X-1G
Command
The reset command performs a physical reset of the CPU and initiates the full
startup sequence on the DNR-X-1G system:
DQ> reset
Stopping DaqBIOS
U-Boot 1.1.3 (PowerDNA 8347 3.2.4) (Mar 24 2014 - 12:31:23) MPC83XX
Clock configuration:
<...many U-Boot messages deleted...>
Net: Freescale TSEC0:- PHY is Realtek RTL8212 (1cc912)
PHY is Freescale TSEC0
W:9140 rg:0 Gig-E controller found
W:1140 rg:0 EthController Freescale TSEC0
Hit any key to stop autoboot: 0
## Starting application at 0xFF800100 ...
Welcome to PowerDNA!
PowerDNA (C) UEI, 2001-2017. Running PowerDNA Firmware on MPC8347A
Built on 13:05:16 Aug 23 2017
RAM size:128MB Flash size:32MB
Initialize uC/OS-II (Real-Time Kernel v.280)
CM-4 PPC8347 detected
6 devices detected
Address Irq Model Option Phy/Virt S/N Pri DevN
-------------------------------------------------------
0xA0000000 2 207 1 phys 0165992 10 0
0xA0010000 2 650 1 phys 0154839 20 1
0xA0020000 0 364 1 phys 0170276 30 2
0xA0030000 2 217 1 phys 0153841 40 3
0xA00C0000 2 20 1 phys 0162268 50 4
0xA00D0000 3 40 1 phys 0162861 60 5
0xA00E0000 3 5 1 cpu 0162789 0 14
-------------------------------------------------------
Current time: 10:19:54 08/30/2017
Starting filesystem... (H)
SD card is not present.
Power DNA version 4.10.0 release build 3
Built on 13:05:16 Aug 23 2017
396MHz MPC8347 DCache:32k uC/OS v.280 is running
Enter 'help' for help.
DQ>