DNR-X-1G Series RACKtangle and HalfRACK Systems
Chapter 4 36
Installation and Configuration
October 2018 www.ueidaq.com
508.921.4600
© Copyright 2018
United Electronic Industries, Inc.
Chapter 4 Installation and Configuration
The following installation and configuration topics are included in this chapter:
• Initial Installation Guide (Section 4.1)
• Initial Boot-up (Section 4.2)
• IP Address Overview & Update Procedures (Section 4.3)
• Network Configuration (Section 4.4)
• Troubleshooting (Section 4.5)
• Updating Firmware (Section 4.6)
• Mounting and Field Connections (Section 4.7)
• Wiring I/O Boards (Section 4.8)
• Repairing (and Upgrading) a DNR System (Section 4.9)
• Configuring a NIC Port for Diagnostic Mode (Section 4.10)
• Disabling Writes to Flash/EEPROM (NVRAM) (Section 4.11)
NOTE: Throughout this chapter, several images show just DNR-6 or DNR-12
systems. Unless otherwise noted, each representation applies to both
systems.
4.1 Initial
Installation
Guide
This section describes the procedure recommended for performing an initial
hardware and software setup when you first receive a DNR-X-1G system:
• Verify shipment contents, Section 4.1.1
• Install software, Section 4.1.2
• Verify communication over serial port (optionally) / initial boot up,
Section 4.2
• Configure IP addresses (if needed), Section 4.3
• Connect your DNR-X-1G system to your host PC or network switch,
Section 4.4 and Section 4.7 (optionally)
To Next Page
Loading...
Need help?
General
