DNR-X-1G Series RACKtangle and HalfRACK Systems
Chapter 5 82
PowerDNA Explorer
October 2018 www.ueidaq.com
508.921.4600
© Copyright 2018
United Electronic Industries, Inc.
Figure 5-18. Screen from Network >> Start Reading Input Data
5.2.4.2.1 Interacting
with I/O
Boards
To read data from an I/O board, select Network >> Start Reading Input Data. The
Value column for any inputs will update, as shown above in the settings panel.
Also in the settings panel, you can add or edit channel names. After editing
names, choose Network >> Store Config to save changes to the board. This is
true for all boards.
Additionally, if you have changed a configuration value, but have not chosen
Network >> Store Config to save them, previous values can be re-read from the
board, using Network >> Reload Config.