UEi RACKtangle DNR-12-1G Series User Manual

DNR-X-1G Series RACKtangle and HalfRACK Systems
Chapter 2 14
The DNR-12-1G Series RACKtangle System
October 2018 www.ueidaq.com
508.921.4600
© Copyright 2018
United Electronic Industries, Inc.
2.5 DNR-12
Power, NIC/
CPU, and I/O
Boards LEDs
& Controls
DNR-12-1G LED indicators are illustrated in Figure 2-10.
The power, CPU, and I/O board LEDs are individually described in Figure 2-11,
Figure 2-12, and Figure 2-13 respectively.
Figure 2-10. DNR-12-1G System Front Panel Arrangement
SD Card
USB B
USB A
NIC 1
NIC 2
Sync/Reset
RS-232
3.3
24
COM
USRR/W
PG
POWER Module 1 Module 2 Module 3 Module 4 Module 5 Module 6
CPU/NIC
Buffer Module 7 Module 8 Module 9 Module 10 Module 11 Module 12
Module
(dual width)
DNR-POWER-DC
Typical
I/O Board
Serial Port
Connector
Status
LEDs
NIC1 Port
NIC2 Port
Temp1 Sensor (on backplane)Temp0 Sensor (on backplane)
Status
LEDs
DB
Connector
V
in
1.5V
User
Overtemp
24V
3.3V
I
in
I/O
Attention
24V
3.3V
(7-12)
(1-6)
Power
Conn.
PowerDNR
PowerDNR
Fan
Switch
0n/off
Power
DB-9
ATT Indicates error when red
R/W Flashes when bus is active
COM Flashes when SD Card is read/written
PG Indicates presence of valid power input
LEDs
DC/DC Module
(Single Slot Model)
USB 2.0
USB 2.0
Controller
DNR-CPU-1000/-XX
CPU/NIC Module
PowerDNR
Slave Port
Port
Sync Conn/
RESET
SD Card
Slot

UEi RACKtangle DNR-12-1G Series Specifications

General

Brand	UEi
Model	RACKtangle DNR-12-1G Series
Category	Network Hardware
Language	English