UEi RACKtangle DNR-12-1G Series User Manual

DNR-X-1G Series RACKtangle and HalfRACK Systems
Chapter 6 100
Programming CPU Board-specific Functions
October 2018 www.ueidaq.com
508.921.4600
© Copyright 2018
United Electronic Industries, Inc.
6.4.5 Password
Command
Some commands (such as mr, mw, set, and store) require entering a user
password. Once the password is entered, these commands become enabled
until firmware reset.
There are two levels of password protection available. The first is user level and
the second is super-user level. Super-user level is currently used only for
updating firmware over the Ethernet link.
• DQ> pswd user
sets up a user level password. First, you’ll be asked about
your old password and then (if it matches) to enter the new password twice.
• DQ> pswd su sets up super-user level password. First, you’ll be asked
about old super-user password and then (if it matches) to enter the new
super-user password twice.
DNR-12 and DNR-6 systems come with both default passwords set to
“powerdna”.
Some DaqBIOS commands require clearing up user or super-user password.
Use DqCmdSetPassword() before calling these functions. The PowerDNA API
Reference Manual notes which functions are password-protected.
6.4.6 Display Table
of Installed
Boards &
Logic Version
Command
The devtbl command is another of the more frequently used commands.
This command displays all I/O boards found and initialized by firmware along
with assigned device numbers.
Use these device numbers in host software to address the I/O devices.
DQ> devtbl
Address Irq Model Option Phy/Virt S/N Pri DevN
-------------------------------------------------------
0xA0000000 2 207 1 phys 0165992 10 0
0xA0010000 2 650 1 phys 0154839 20 1
0xA0020000 0 364 1 phys 0170276 30 2
0xA0030000 2 217 1 phys 0153841 40 3
0xA00C0000 2 20 1 phys 0162268 50 4
0xA00D0000 3 40 1 phys 0162861 60 5
0xA00E0000 3 5 1 cpu 0162789 0 14
-------------------------------------------------------
The devtbl command with the logic option added displays the CPU logic
version on each installed I/O board:
DQ> devtbl logic
Logic information:
DevN Mod-opt Logic CLI CLO LogOption
-----------------------------------------------
0 207-001 02.12.21 512 512 10127E0
1 650-001 02.11.36 1024 0 43000040
2 364-001 02.11.0A 0 4096 30000A0
3 217-001 02.11.9F 2048 512 90024E0
4 020-001 02.0D.09 0 0 101800E
5 040-001 02.10.C4 0 0 1010081
14 3006-001 02.12.3E 0 0 30303720
-----------------------------------------------

UEi RACKtangle DNR-12-1G Series Specifications

General

Brand	UEi
Model	RACKtangle DNR-12-1G Series
Category	Network Hardware
Language	English