146
Connecting/disconnecting a Bluetooth device automatically
If your Bluetooth device is proximity-system enabled, you can activate Proximity
Monitoring. If the paired device comes into the immediate vicinity of the
OpenScape CP 600, the connection is established automatically. If the device is
removed from the vicinity, the connection is dropped automatically. The default
setting is for Proximity Monitoring to be disabled.
@ If nec. Press Main Menu key.
Open using the Softkey.
Open using the Softkey.
if nec. j Enter and confirm the User password.
Open using the Softkey.
Open using the Softkey.
Paired devices are displayed.
€ Select the relevant Bluetooth device.
« and open it. The status of the device is displayed and activated, for example,
with "(aud)".
Open the Configuration menu with the Softkey.
€ Select the "Proximity Monitoring" function.
Activate with the Softkey.
Proximity Monitoring Is activated.
Setting the Proximity threshold
You can set the "Proximity threshold" if appropriate to suit the required circum-
stances.
Open the setting for the Proximity threshold by selecting the Softkey
1
.
Use the Softkey to increase the proximity.
or
Use the Softkey to reduce the proximity.
Service/Settings
_
$
User:
-
_
$
Bluetooth
-
_
Paired devices
-
_
You receive a message that the OpenScape CP600 is now visible for other
Bluetooth devices while you are in this menu.
?
Headset
- Å
¢_
Setup
U
_
Proximity Monitoring
¦_
?
Headset
-Å Å¡
¢_
..Proximity threshold
K
_
1. The display shows the current setting
X
_
Å’
_
To Next Page
Loading...
Need help?
General
