153
Line/trunk keys
On a MultiLine phone the freely programmable keys function as line/trunk keys.
Every key configured as a "line/trunk key" (key marking: Ln: X) corresponds to
a line.
As a team member, you yourself can assign the following functions to keys
ïƒ page 84:
• Direct station selection (DSS)
• Group call on/off
(not for main phone in the management/administration team)
• Ring transfer on/off
(only in management/administration team)
Otherwise, you can assign a key with the "MULAP forwarding" (call forwarding)
function for each line.
LED displays for line/trunk keys
Accepting calls on the line/trunk keys
Requirement: Your phone rings and/or the line/trunk key flashes quickly.
Press quickly flashing line/trunk key on the OpenScape Key Module 600.
^ Lift the handset.
or With handset on hook: Speakerphone mode.
Dialing with line/trunk keys
Press the free line/trunk key of the OpenScape Key Module 600 or via which you
wish to establish your connection.
j Dial phone number.
^ If the participant answers: Lift the handset.
or With handset on hook: Speakerphone mode.
LED Meaning
_
Off – the line is in idle mode.
£
flashes
1
1 Flashing keys are represented by this icon in this manual, without reference to the frequency of
flashes. The flashing interval represents different statuses, which are described in detail in the
corresponding sections of the manual.
– Incoming call on the line
– "Hold reminder" is activated
– the line is on "Hold".
¤
On – the line is busy.
Ln -
£
Ln -
_
To Next Page
Loading...
Need help?
General
