Unify OpenScape CP600 - Programming Function Keys; Function Keys Setup

84
Programming function keys
Your can assign frequently used functions, numbers or services to the keys of
your OpenScape Key Module 600. You can save destination call numbers to the
second level.
The keys can be programmed in three ways:
• Press and hold selected key
• Call up via the Service menu
• Call up via user settings
The following is a description of the set up by pressing and holding the selected
key.
Function keys setup
See also the information in  page 51.
Example: "Disconnect key" set up
Hold down the Function keys on the OpenScape Key Module 600 to which a
function is to be assigned until the programming prompt is displayed.
or
@ If nec. Press Main Menu key.
Open using the Softkey.
Select desired page (1 to 4).
Press and hold the Function keys to be programmed.
€ Select "Assign telephone function"
Confirm.
Confirm.
€ Select "Calls:"
Confirm.
Confirm. The key is programmed.
You can also change the standard key label
€ Select "Key labelling "
Confirm.
_
Favorites
_
Favorites (1/2)
Page 1
Q
_
_
Assign telephone function
-
_
Modifying keys
_
Calls
-
_
Release key
_
Key labelling
_