Vaisala AWS330 - Page 119

Chapter 5 __________________________________________ Software Configuration and Operation
VAISALA______________________________________________________________________ 115
If AWS330 is connected to the Internet or other network where NTP
service is available, further timekeeping can be automated by configuring
the NTP client into use.
1011-016
Figure 65 Setting NTP Client Parameters
Table 20 NTP Parameters
Set Name Parameter
Name
Use
NTP interval Interval [s] to check and adjust time. Once
per hour (3600) is the recommended
shortest period.
NTP server1 NTP server to read the time from. For public
servers, see http://www.pool.ntp.org/en/
.
NTP timetol Time error tolerance [s] for adjusting the real
time clock. In other words, if error is equal to
or greater than this parameter, RTC is
adjusted to match the NTP server time.