Chapter 5 __________________________________________ Software Configuration and Operation
VAISALA______________________________________________________________________ 139
Serial Line Connections
To add an Address Book entry for a serial line connection, proceed as
follows:
1. On the Settings menu, select Address Book.
2. Select New. The fields for selecting new connection parameters are
displayed.
3. From the Type list, select the type of the connection; that is, select
Serial Port. The fields for selecting a serial port connection, shown
Figure 83 below, are displayed.
0905-008
Figure 83 Creating Serial Line Address Book Entry
4. In the Name field, enter an alphanumeric string that uniquely
identifies the connection you are creating in the Address Book.
5. If you have multiple QML loggers on the same network and you
are going to access them over the same serial connection, you will
need a unique identifier for each logger. To uniquely identify the
logger for which you are creating an Address Book entry, enter a
unique alphanumeric string in the Station id field. If you only have
a single logger on the network, you can leave the Station id entry
blank.
To Next Page
Loading...
