Chapter 5 __________________________________________ Software Configuration and Operation
VAISALA______________________________________________________________________ 143
1101-024
Figure 85 Creating Dial-Up Connection Address Book
Entry
4. In the Name field, enter an alphanumeric string that uniquely
identifies the connection you are creating in the Address Book.
5. If you have multiple QML loggers on the same network and you
are going to access them over the same dial-up connection, you
need a unique identifier for each logger. To uniquely identify the
logger for which you are creating an Address Book entry, enter a
unique alphanumeric string in the Station id field. However, if you
only have a single logger on the network, you can leave the Station
id entry blank.
6. In the Command wait timeout (ms) field, enter a value in
milliseconds that specifies for how long AWS Client will wait for
the logger to respond when AWS Client sends a requests over the
dial-up connection. If the request, for instance, a log file download,
succeeds within the timeout, a success message is displayed. If the
request fails, a failure message is displayed instead, and you have
the option to try again at a later time. Factors such as the current
load on the logger, delays in the connection, and the response
length affect whether or not the timeout will expire during a
request. In case the system has a large amount of static parameters,
To Next Page
Loading...
Need help?
General
