Chapter 5 __________________________________________ Software Configuration and Operation
VAISALA______________________________________________________________________ 145
Table 37 Settings in AWS Client Options Window
Setting Description
Locale
User interface language used in AWS
Client. If AWS Client has not been
localized for the selected language,
the user interface will remain in
English.
1)
Setup file download directory
Default download directory for QML
logger setup files. You can either
enter the path for your directory or
select Browse and browse for the
directory.
Setup file upload directory
Default upload directory for QML
logger setup files. You can either
enter the path for your directory or
select Browse and browse for the
directory.
PDF reader path
Location of the PDF reader on the
workstation on which the AWS Client
is installed. The AWS Client help file is
in PDF format and needs a reader.
Trace log directory
AWS Client logs the information sent
by the QML logger during the terminal
session to a file. The trace log
directory specifies the location of the
trace log.
Trace log on
When selected, the Trace log on
option causes a trace log to be
created. For troubleshooting
purposes, you can, for example, log
your commands and the responses
given by the QML logger.
Sleep commands enabled
Enables the Sleep command for
setting the QML logger to a power-
saving mode as well as the Wakeup
command for powering up the logger
after it is put to sleep.
Send close before open
Always send the Close command
before attempting to open terminal
connection.
Secure setup upload
Use secure setup upload procedure
when uploading the setup. Using this
option will cause the setup upload to
take more time, but using the option is
recommended especially when
uploading setups over an unreliable
connection.
Terminal line wrap
Folds overlong lines in the terminal
window onto the next line.
Command line length
Maximum length for a command sent
from the command line to the QML
logger. The default value is
80 characters. This can be set to a
smaller value, which, however, must
match the value specified in the setup
file on the logger. For URL settings,
80 characters might not be long
To Next Page
Loading...
