User's Guide ______________________________________________________________________
220 _________________________________________________________________ M211296EN-A
Example:
/ W> warnings
Warning: Break
occurred 9 times first in uart.cpp[84]
during thread: 00019F60 [AbsTimerT]
object pointer: 106C [component: COM0]
Warning: Frame
occurred 14 times first in uart.cpp[83]
during thread: 00019F60 [AbsTimerT]
object pointer: 106C [component: COM0]
The Break and Frame warnings mean that most likely you have turned
your PC off and on again. This causes no trouble and you can clear the
warnings.
Warning: Device reset
occurred 1 times first in
c:/libs/MAWS/adcl/kernel/idle.cpp[52]
during thread: 00001694 [Idle]
object pointer: 163C [component: Idle]
The above warning means that you have reset the QML logger. This
causes no trouble and you can clear the warning. If you have not reset the
QML logger and the warning still occurs, contact Vaisala technical
support (see section Technical Support on page 234).
Warning: Data missing
occurred 2 times first in
h:/MAWS/software/adcl/report/confrep.cpp[414]
during thread: 00019C0C [AbsTimerT]
object pointer: 33A94 [component: MyRep1]
If you receive the above warning, check that the parameters sname,
pslevel, and altitude are set.
To see active errors, type errors. To clear active errors, type
errors clear. Errors indicate that there is something wrong with the
sensors or configuration. Write down the error information and contact
Vaisala technical support as described in section Technical Support on
page 234.
To Next Page
Loading...
Need help?
General
