Chapter 7 ___________________________________________________________ Troubleshooting
VAISALA______________________________________________________________________ 231
8. If WMT703 responds with prompt >, the connection has been
successfully opened.
NOTE
When entering commands for WMT703, instead of terminating
command with ENTER, use the function key programmed in step 3
on page 230 to send <CR><LF> to the sensor. Also note that
WMT703 does not echo characters when using RS485 link.
For additional troubleshooting instructions, see WMT700 User's Guide,
manual M211095EN, included on the AWS330 installation CD.
To Next Page
Loading...
