Press the key under the display. The display is not touch sensitive.
6.2.2 Display setup
Selecting MENU / MENU A / MENU B or SENSOR A or SENSOR B (depending on your Main
display format) in the Main display gives the menu display. Choose 4 DISPLAY SETUP to
change the Main display format and bar graph settings, to adjust backlight or contrast and
to invert the display. In DTR program version 2.0 or newer you can also switch between the
existing display languages.
Figure 25 Display setup menu
Main display format: As shown in Figure 23 (page 50), there are four dierent Main display
formats: the dual sensor format shows information on both sensors while the three dierent
single sensor formats show selected information on one sensor at a time. Choose 1 MAIN
DISPLAY FORMAT in the Display setup menu to change the Main display. The current format
is shown on the display format selection display, as shown in the figure below.
Chapter 6 – Startup and use
53