EasyManuals Logo

WAGO I/O-SYSTEM 750 User Manual

WAGO I/O-SYSTEM 750
468 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #319 background imageLoading...
Page #319 background image
WAGO-I/O-SYSTEM 750 CANopen Master and Slave 319
750-8208 PFC200 CS 2ETH RS CAN DPM
Manual
Version 1.1.0, valid from FW Version 02.06.20(09)
The value of the objects can be changed. To do this, mark the field in question in
the “Value” column and overwrite the value with your input, then press [Enter].
On initialization of the CAN bus, the set values will be transmitted to the slaves as
SDOs.
An example here is the activation of sending PDOs on a change in analog values,
which is normally deactivated:
Figure 122: Adapting SDOs

Table of Contents

Other manuals for WAGO I/O-SYSTEM 750

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the WAGO I/O-SYSTEM 750 and is the answer not in the manual?

WAGO I/O-SYSTEM 750 Specifications

General IconGeneral
BrandWAGO
ModelI/O-SYSTEM 750
CategoryI/O Systems
LanguageEnglish

Related product manuals