WAGO I/O-SYSTEM 750 User Manual

WAGO-I/O-SYSTEM 750 Appendix 431
750-8208 PFC200 CS 2ETH RS CAN DPM
Manual
Version 1.1.0, valid from FW Version 02.06.20(09)
15.2.1.6 BusDiag.lib
The controller 750-8208 supports the following function blocks of the
“BusDiag.lib” library:
- DiagGetBusState
- DiagGetState
The document containing a description of this library and the function blocks it
includes is available for download on the Internet at www.wago.com.
The values for the input variables “DEVICENUMBER” of the
“DiagGetBusState” and “DiagGetState” functions are based on the particular
device and bus system and are as follows for the controller “PFC200 CS 2ETH
RS CAN DPM” (750-8208):
Table 314: Input Variable “DEVICENUMBER”
Bus System
Value
Internal data bus
0
MODBUS
1
CANopen
2
PROFIBUS
3
15.2.1.7 mod_com.lib
The controller 750-8208supports the following function blocks of the
“mod_com.lib” library:
- ADD_PI_INFORMATION
- CRC16
- FBUS_ERROR_INFORMATION
- GET_DIGITAL_INPUT_OFFSET
- GET_DIGITAL_OUTPUT_OFFSET
- KBUS_ERROR_INFORMATION
- MOD_COM_VERSION
- PI_INFORMATION
- SET_DIGITAL_INPUT_OFFSET
- SET_DIGITAL_OUTPUT_OFFSET
- SLAVE_ADDRESS
The document containing a description of this library and the function blocks it
includes is available for download on the Internet at www.wago.com.
15.2.1.8 SerComm.lib
The controller 750-8208supports the following function blocks of the
“SerComm.lib” library:
- SERCOMM
- SERCOMM_VERSION

WAGO I/O-SYSTEM 750 Specifications

General

Brand	WAGO
Model	I/O-SYSTEM 750
Category	I/O Systems
Language	English