EasyManuals Logo

WAGO I/O-SYSTEM 750 User Manual

WAGO I/O-SYSTEM 750
468 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #321 background imageLoading...
Page #321 background image
WAGO-I/O-SYSTEM 750 CANopen Master and Slave 321
750-8208 PFC200 CS 2ETH RS CAN DPM
Manual
Version 1.1.0, valid from FW Version 02.06.20(09)
10.3.5 CANopen Slave Control Configuration
An application must be configured in CODESYS before it can access the
connected CAN network.
To add the CANopen slave to the control configuration, right-click “COS
unused[Slot]” and select “Replace element -> CANopen slave”.
Figure 124: Attaching a CANopen Slave
Right-click on CANopen Slave and select “Edit” to configure the slave.
Figure 125: Configuring a CANopen Slave

Table of Contents

Other manuals for WAGO I/O-SYSTEM 750

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the WAGO I/O-SYSTEM 750 and is the answer not in the manual?

WAGO I/O-SYSTEM 750 Specifications

General IconGeneral
BrandWAGO
ModelI/O-SYSTEM 750
CategoryI/O Systems
LanguageEnglish

Related product manuals