WAGO I/O-SYSTEM 750 User Manual

384 Diagnostics WAGO-I/O-SYSTEM 750
750-8208 PFC200 CS 2ETH RS CAN DPM
Manual
Version 1.1.0, valid from FW Version 02.06.20(09)
12.2.3 Meaning of Blink Codes and Procedures for
Troubleshooting
This section describes the diagnostics presented as blink codes via the I/O LEDs.
If the diagnostics cannot be cleared by the measured specified for them, contact
WAGO support. Be ready to explain to them the blink code that is displayed.
Phone: +49 571 887 555
Fax: +49 571 887 8555
E-mail: support@wago.com
Table 251: Overview of Error Codes, I/O LED
Error code
Explanation
1
Hardware and configuration error
2
Configuration error
3
Internal data bus protocol error
4
Physical error on the internal data bus
5
Internal data bus initialization error
6
Not used
7
Not used
8
Not used
9
CPU exception error

WAGO I/O-SYSTEM 750 Specifications

General

Brand	WAGO
Model	I/O-SYSTEM 750
Category	I/O Systems
Language	English