Watts AERCO Edge [ii] - Page 126

Edge [ii] Controller Operation Manual
SECTION 6 – ADVANCED SETUP
OMM-139_E • 8/25/2020 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page 126 of 196
TABLE 6.6: Application = DHW
DHW Operating Mode =
Constant
Setpoint
Remote
Setpoint
DHW Setpoint
✓
DHW Rmt Setpt Signal
✓
DHW Rem Setpt Source (If DHW Rem Setpt Signal = 1-5V or 0-5V)
✓
DHW Pump Unit Address
✓
✓
DHW Setup
✓
✓
DHW Pump Control Type
✓
✓
DHW Pump Off Time
✓
✓
DHW Aquastat Enable (if DHW Setup = 2 or 4 Port Tank)
✓
✓
Aquastat Unit Addr (if DHW Aquastat Enable = Enabled)
✓
✓
DHW Setpoint Offset
✓
✓
Setpoint Ramp Rate
✓
✓
TABLE 6.7: Application = Other
Other Operating Mode =
Constant
Setpoint
Remote
Setpoint
Other Rmt Setpt Signal
✓
Other Rmt Setpt Source (if Other Rem Setpt Signal = 1-5V or 0-5V)
✓
Other Setpoint
✓
NOTE:
The following tables show the parameters that are unique to these Applications. However, all
the Applications below also include the parameters in the SH, DHW and/or Other
Application tables above if the Application includes SH, DHW or Other.
TABLE 6.8: Application = SH+DHW-1-Vlv and SH+DHW-2-Vlv
Application =
SH+DHW-1-Vlv
SH+DHW-2-Vlv
Unit 1 Designation, up to
Unit 16 Designation
✓
✓
Default Swing Boiler Load
✓
✓
SH Swg Vlv Unit Add
✓
✓
DHW Swg Vlv Unit Add
✓
SH Valve Open Time
✓
✓
DHW Valve Open Time
✓
TABLE 6.9: Application = Other+SH-Stpt Prty
Other SH PRI Setpt Mode
Other SH PRI Setpoint (if Other SH PRI Setpt Mode = Constant Setpoint)
Other SH PRI Remote Signl (if Other SH PRI Setpt Mode = Remote Setpoint)