上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
37 / 131
The distance between the start point and the center point is the radius.
4. Left click to specify the end point.
The system generates a toolpath in counterclockwise direction.
4.1.4 Draw an Ellipse
To draw an ellipse, do the following:
1. Select the ellipse drawing tool.
2. Left click to specify the center point.
3. Left click to specify two points separately.
The distances between the center point and the two points are major axis and
minor axis of the ellipse separately.
4.1.5 Draw an Elliptic Arc
To draw an elliptic arc, do the following:
1. Select the elliptic arc drawing tool.
2. Draw an ellipse. Refer to Draw an Ellipse for details.
3. Left click to specify the start point and the end point separately.
The system generates a toolpath in counterclockwise direction.
4.1.6 Draw a Polygon/Star
To draw a polygon/star, do the following:
1. Select the polyline/star drawing tool.
2. Enter the following number in toolbar:
– Regular polygon: enter the number of edges in Edges input box.
– Star: enter the number of vertexes in Vertexes input box.
3. Press Enter.
4. Left click to specify the center point and a vertex separately.
4.1.7 Enter Text
This operation is used to draw text in an advertisement board.
To enter text, do the following:
1. Select the text drawing tool.
To Next Page
Loading...
