上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
50 / 131
4.3.8 Explode Objects
This operation is used to delete extra lines, so as to trim the toolpath. It usually
applies to polyline.
Exploding characteristics differs in object type:
• If the object is a group, exploding equals to ungrouping.
• If the object is text, exploding equals to turning the text into polylines.
To explode objects, do the following:
1. Select the target objects.
2. Do one of the following:
– In menu bar, click Object → Explode.
– In drawing window, right click and select Explode.
Exploding result shows as follows:
4.3.9 Break Objects
This operation is used to cut objects into several polylines in the following
situations:
• Connect the cutting part to surrounding material. It equals to micro joint.
• Cut extra objects during drawing objects. It equals to explode micro joint.
To break objects, do one of the following:
• Automatically break objects.
Used to break all the selected objects at the same time.
• Manually break an object.
Used to break one object each time by selecting where to break.
To Next Page
Loading...
