上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
56 / 131
2. To switch to circular tube intersection interface, click Intersecting.
3. Set intersection parameters and select a hole type according to the shape of the
tube:
– Circle: generate a single hole or two holes on the primary tube. Or cut
the end of the auxiliary tube according to the shape of the hole on the
primary tube.
– Rect: only generate a single rectangular hole.
4. Optional: Set parameters of cutting position:
– W: the angle between the cutting objects and the workpiece origin.
– Y: the vertical distance between the cutting objects and the workpiece
origin.
5. Optional: To enable verticle intersection cutting or inside diameter cutting,
check Set Vertical Insect or Inner First.
To Next Page
Loading...
