上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
55 / 131
– Left-right
The tube rotates 180° in X-axis direction, which equals to the current
tube face rotates 180°.
– Front-back-left-right
The tube rotates 180° from forwards to backwards and then rotates
180° from left to right.
– Left-right-front-back
The tube rotates 180° from left to right and then rotates 180° from
forwards to backwards.
The system generates and arranges the copied machining objects in drawing
window automatically.
4.3.12 Set Wizard (in Tube Cutting Configuration)
This operation is used to make it easy to generate and load toolpath in tube cutting
configuration through wizard.
Toolpath can be generated in the following methods:
• Circular tube intersection
Used to insert a circular tube or a rectangular tube (auxiliary tube) into another
circular tube (primary tube) and generate a circular hole or a rectangular hole.
• Tube cutting
Used to cut a tube and generate cutting toolpath on the tube. The tube can be
one of the following:
– Circular tube
– Rectangular tube
– Ellipse tube
– Waist type tube
After setting wizard, the system loads the generated toolpath automatically.
Set Circular Tube Intersection
To set circular intersection, do the following:
1. To open Tube Cutting Wizard dialog box, do one of the following:
– In drawing toolbar, click .
– In menu bar, click Draw → Pipe Cutting Guide.
To Next Page
Loading...
