上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
70 / 131
Set dialog box pops up:
3. Select a lead line type.
Lead line type depends on the cutting technic.
4. Set related parameters of the lead line.
5. Set position of the lead line:
– If you select a closed object, select a lead line strategy and set seal
length:
• Edge first: set the lead line at the center position of the longest
edge of the object.
• Corner first: set the lead line at the position with larger angle in
the object.
• Specify Pos: used to enble Advanced function. You can set
segment number and position ratio.
• By Mouse: the cursor turns into . Click on the edge of the
object to specify the position of the lead line.
To Next Page
Loading...
