上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
71 / 131
– If you select an unclosed object, select a leading method according to the
machining direction:
• Lead in
Left Side/Right Side: lead in on the left/right of the machining
direction.
• Lead out
Left Side/Right Side: lead out on the left/right of the machining
direction.
6. Optional: To modify the lead line, do the following:
1. Do one of the following:
• In menu bar, click Object → Lead Line → Set Start Point.
• In drawing window, right click and select Lead Line → Start
Point.
2. Do one of the following:
• To modify the position of the lead-in line, click on the edge of the
object.
• To draw a line-type lead-in line from outside to the edge on the
object, click on the outside and the edge of the object.
If you need to check the lead line, do one of the following:
• In menu bar, click Object → Lead Line → Check Lead-in/out Line.
• In drawing window, right click and select Lead Line → Check Lead-in/out
Line.
The system checks and cuts the lead line automatically and properly.
To Next Page
Loading...
