上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
72 / 131
Result of lead line shows as follows:
Lead Line Parameters
Angle
For a line-type lead line, it refers to the angle between the lead line and the tangent
line of the intersection.
For an arc-type lead line, it refers to the central angle.
Radius
For a hook-type lead line, it refers to the radius of the arc.
Length
For a line-type/arc-type lead line, it refers to the length of the line/arc.
For a hook-type lead line, it refers to the sum of the radius of the arc and the length
of the line.
Add Tiny Circle at Start Point
Add a tiny circle at the start point of the lead-in line, so as to solve the problem that
the accumulation of slag influences cutting effect during piercing a thick plate.
Add Tiny Circle at Start Point-Radius
Radius of the hole at the start point of the lead line.
To Next Page
Loading...
