Maintenance
2722−1/A2
Winterthur Gas & Diesel Ltd.
1/ 2
Injection Valve
Installation of Injection Valve with FAST
1. General 1..........................................................
2. Installation 2.......................................................
1. General
Inspect the Injector seat in the cylinder cover.
Check the spring pack height (must be according Fig.1).If a spring pack is not
according to the requirements and it is the only available spring pack, the same
tightening instructions are to be followed. The old spring pack must be repaired or
replaced as soon as you get the new spring pack.
Note: It is not recommended that diesel oil (gas oil) is used if the injection valve
is put into storage after these checks. The injection valve can get
corrosion.
2020
Injection Valve: Installation Injection Valve with FAST
To Next Page
Loading...