wsm M8540NARROW - Separating Rear Axle Case from Transmission Case

BRAKES
M8540Narrow, M9540Narrow, WSM
N5-S6
Lift Rod, Lower Link and Top Link
1. Remove the top link (1).
2. Remove the cotter pin and slotted nut (5).
3. Remove the stabilizer bracket (2).
4. Remove the lift rod (3) with lower link (4).
(When reassembling)
• Tighten the slotted nut (5) by hand and assemble the cotter pin.
9Y1210236RAS0004US0
Rear Wheel
1. Place the disassembling stand under the transmission case.
2. Install the front axle rocking restrictor (1) to the front axle
bracket on both sides (refer to "8. SPECIAL TOOLS" at "NG.
GENERAL" section).
3. Remove the both rear wheels.
9Y1210236RAS0005US0
(2) Separating Rear Axle Case from Transmission Case
Rear Axle
1. Remove the rear axle assembly (1), refer to the "3.
DISASSEMBLING AND SERVICING" at "N4 REAR AXLE"
section.
9Y1210236BRS0011US0
Tightening torque
Stabilizer bracket mounting
screw (M16, 9T)
260 to 304 N·m
26.5 to 31.0 kgf·m
191.8 to 224.2 lbf·ft
Stabilizer bracket mounting
nut (M16, 7T)
197 to 225 N·m
20.0 to 23.0 kgf·m
145 to 166 lbf·ft
(1) Top Link
(2) Stabilizer Bracket
(3) Lift Rod
(4) Lower Link
(5) Slotted Nut
Tightening torque Rear wheel mounting nut
260 to 304 N·m
26.5 to 31.0 kgf·m
192 to 224 lbf·ft
(1) Front Axle Rocking Restrictor
(1) Rear Axle Assembly [A] ROPS Model
[B] CABIN Model
KiSC issued 07, 2013 A