CLUTCH
M8540Narrow, M9540Narrow, WSM
N2-S10
(3) CABIN Model
Rear Wheel (Wheel Model)
1. Set the disassembling stand under the transmission case
secure.
2. Remove the both rear wheels (1).
(When reassembling)
9Y1210236CLS0020US0
Removing Compressor and Condenser
1. Refer to "[2] DISASSEMBLING AND ASSEMBLING" at "N10.
CABIN" section.
9Y1210236CLS0021US0
Heater Hose, Accelerator Wire, Bonnet Support and Steering
Joint Shaft
1. Refer to "[2] DISASSEMBLING AND ASSEMBLING" at "N10.
CABIN" section.
9Y1210236CLS0022US0
Floor Mat and Panel Cover
1. Refer to "[2] DISASSEMBLING AND ASSEMBLING" at "N10.
CABIN" section.
9Y1210236CLS0023US0
Brake Rod (Parking)
1. Refer to "[2] DISASSEMBLING AND ASSEMBLING" at "N10.
CABIN" section.
9Y1210236CLS0024US0
Removing Control Rods and Brake Hoses
1. Refer to "[2] DISASSEMBLING AND ASSEMBLING" at "N10.
CABIN" section.
9Y1210236CLS0025US0
Auxiliary Control Valve Cable and Ground Cable
1. Refer to "[2] DISASSEMBLING AND ASSEMBLING" at "N10.
CABIN" section.
9Y1210236CLS0026US0
Brake Rod (L.H.), Shuttle Cable and Clutch Cable
1. Refer to "[2] DISASSEMBLING AND ASSEMBLING" at "N10.
CABIN" section.
9Y1210236CLS0027US0
Cabin Assembly
1. Refer to "[2] DISASSEMBLING AND ASSEMBLING" at "N10.
CABIN" section.
9Y1210236CLS0028US0
Tightening torque Rear wheel mounting nut
260 to 304 N·m
26.5 to 31.0 kgf·m
191.8 to 224.2 lbf·ft
(1) Rear Wheel
To Next Page
Loading...
