wsm M8540NARROW - Page 93

CLUTCH
M8540Narrow, M9540Narrow, WSM
N2-S9
Wire Harness
1. Remove the ground cable screw (1).
2. Disconnect the connector (2) from solenoid assembly.
3. Disconnect the breather hose (3).
9Y1210236CLS0017US0
Panel Board
1. Remove the steering post cover (3) and panel board (2).
2. Remove the rubber sheet (4) and shield (1) both side.
9Y1210236CLS0018US0
Hydraulic Pipe and Brake Hose
1. Remove the hydraulic pipes (1) and (2).
2. Disconnect the hydraulic brake pipes (3) and (4).
(When reassembling)
• Be sure to bleed the air from hydraulic brake system. (Refer to
the "5. BRAKE" section.)
9Y1210236CLS0019US0
(1) Screw
(2) Connector
(3) Breather Hose
(1) Shield
(2) Panel Board
(3) Steering Post Cover
(4) Panel Board
Tightening torque Brake pipe retaining nut
16.0 to 24.0 N·m
1.6 to 2.5 kgf·m
11.8 to 17.7 lbf·ft
(1) Hydraulic Pipe
(2) Hydraulic Pipe
(3) Brake Pipe
(4) Brake Pipe
KiSC issued 07, 2013 A