Xerox 8850 - Page 102

03/2003
4-26
8850/ 510DP
REP 8.1
Repairs and Adjustments
4. (Figure 3): Remove the Lower Sheet Feed Assembly from the Printer.
Figure 3 Removing the Lower Sheet Feed Assembly From the Printer
5. Place the Lower Sheet Feed Assembly on a clean, flat surface.
Replacement
1. (Figure 4): Prepare the Lower Sheet Feed Assembly for reinstallation into the Printer.
Figure 4 Preparing the Lower Sheet Feed Assembly
1
Grasp the Lower Sheet Feed Assembly by the two air
ducts, located at either side of the Lower Transport Frame
Lower Sheet Feed
Assembly
2
Lift the Lower Sheet Feed Assembly free of
the Air Duct holes, and guide the assembly
forward and out of the Printer
1
Ensure that the baffles are correctly
seated into the Lower Sheet Feed
Assembly frame
Plastic baffle tab should be seated in
frame cutout (both sides)