03/2003
4-50
8850/ 510DP
REP 8.16
Repairs and Adjustments
6. (Figure 5): Remove the following Printer left side hardware.
Figure 5 Removing the Printer Left Side Hardware
7. Remove the Media Exit Drive Roll from the Printer.
Replacement
1. (Figure 6): Reinstall the Media Exit Drive Roll in the Printer.
NOTE: The drive side (right side) of the Media Exit Drive Roll Shaft can be identified by
the presence of one E-ring groove and a milled flat for the Media Exit Drive Pulley and
bearing.
Figure 6 Identifying the Right Side of Exit Drive Roll Shaft
1
Remove the E-ring
2
Remove the plastic bearing
E-ring groove
Milled flat for Media Exit
Drive Pulley & bearing
To Next Page
Loading...
