03/2003
4-130
8850/ 510DP
REP 10.8
Repairs and Adjustments
2. (Figure 2) and (Figure 3): Remove the Upper Sheet Feed Housing of the Fuser.
NOTE: Place your hand under the area where the screws will be removed to support the
Upper Sheet Feed Housing to prevent it from falling off the fuser.
Figure 2 Removing the screws securing Upper Sheet Feed Housing
3. (Figure 3): Remove the Upper Sheet Feed Housing.
Figure 3 Removing the Upper Sheet Feed Housing
1
Support the Upper Sheet Feed Housing from
falling while performing the Step 2
2
Remove the two
screws
1
Lower the Upper Sheet Feed Housing and
pull to the left to disengage the tabs from
the right side frame
To Next Page
Loading...
