Xerox Phaser 4500

Error Messages and Codes 3-25
“No Paper in Tray 4\ Press i” Tray 4 empty — — Go to
page 3-63.
“Maintenance Kit is Near End
of Life\ Press i”
N/A — — —
“Replace Maintenance Kit” N/A — — Go to
page 3-69.
“Stacker Is Full, Unload
Paper\ Press i”
Stacker output tray full — — Go to
page 3-67
“Standard Output Tray Is Full,
Unload Paper\ Press i”
Output tray full — — Go to
page 3-68
“Tray 3 Failure\ Press i” E11-1 Tray 3 unit fail — 6 Go to
page 3-52
“Tray 3 or 4 Failure\ Press i” E11-2 Tray 3 or 4 unit fail — 7 Go to
page 3-52
“Duplex Unit Failure\ Press i” E9-1 Duplex unit fail — 8 Go to
page 3-50.
“Stacker Unit Failure\ Press i” E9-2 Stacker unit fail — 4 Go to
page 3-51.
“Close Duplex Unit Cover\
Press i”
Duplex cover open — — Go to
page 3-57.
“Close Stacker cover\
Press i”
Stacker cover open — — Go to
page 3-58.
“Invalid Configuration Card\
Press i”
N/A — — —
“Configuration Card Missing\
Press i”
N/A — — —
Error Message Summary
Front Panel Message Diagnostic Message
Engine
Errors
Jam
Errors
Procedure
to Use