FRU Disassembly 8-43
1. Remove the Print Cartridge and Paper Cassettes.
2. Remove any optional 550-Sheet Paper Feeder(s) (page 8-93).
3. Lay the printer on its right side.
Note
Take care not to scratch or mar the printer covers.
4. Squeeze the actuator latch hooks together and lift the actuator off the pivot shaft.
5. Release the sensor harness wires from the restraints.
6. Release the sensor latches as indicated by the arrows in the drawing to free the
sensor from the holder.
7. Unplug connector P/J260 from the sensor and remove the sensor from the printer.
To Next Page
Loading...
